Setting up the D-Link dir-620 router

To a simple user from WiFi router All you need is for it to transmit the Internet to your computer or laptop efficiently and uninterruptedly. And for this, it needs to be configured correctly. Providers usually charge an additional fee for a consultation or calling a technician. Therefore, now we offer a short instruction on how to understand the settings of the D-Link DIR-620 router at home. 1. Check the settings on the computer. To do this, go to the Control Panel “Network connections” - “Local network”. In the properties you need to switch to protocol 4 TCP/IPv4 and select “Properties” again. A window will open in which you can select the following checkboxes:



2. Most providers use the PPPoE connection type, so let's look at the necessary parameters to configure it.

We enter the router settings page using any browser. In the address line enter 192.168.0.1. The client verification window pops up. Enter admin in both fields. Before you is a standard page of settings.

We are looking for Advanced settings – Network – WAN. A small list will appear, consisting of just one Dynamic Connection. We delete it because it is not needed. Instead, click “Add”. Next we follow the positions in the picture:



Instead of Beeline, we indicate our provider, and we confirm the login and password with him. This information and the server address must be specified in the contract. Save the settings.

3. Now it's time to get started to Wi-Fi distribution. In the tab of the same name, go to Basic Settings. The SSID field is intended to indicate the name of the future network. In the Security Settings section, specify the password. You can now connect to a wireless network by selecting its name in the networks status panel. So, the D-Link DIR-620 router is configured in three stages: configuration on the computer, in the browser and connection. All information about login and passwords, gateway addresses must be clarified with the regional provider.