Asus RT G32 setup

If you recently became the owner of an Asus RT G32 router and encountered certain problems during its connection and configuration, then you have come to the right site. In this article we will look at the most common problems that you encounter when setting up this router, and also tell you about some operating tricks. First, you must definitely ask your provider for the following configuration features that will be entered directly during setup: protocol (PPTP, L2TP, PPPoE), IP properties (static or dynamic, automatic or manual assignment of IP and DNS), as well as the presence (or absence) binding the network card by MAC address. It also wouldn’t hurt to find out if a special login and password have been set for logging into the router’s control panel.

In the next step, our path lies in the properties of the local network connection (Control Panel - Network and Sharing Center - our Internet connection - left-click on it - Properties). We look for “Internet Protocol Version 4 (TCP/IPv4), click on “Properties.” In the “General” tab, click “Obtain an IP address automatically” and “Obtain a DNS server address automatically.” Click “OK.”

At this point, you should already have an Ethernet cable connected from your computer to the router, into the LAN 1 connector. It is recommended to reset the settings before the first setup - this is done very easily: press the Reset button for 10 seconds.



Next we launch any of the Internet browsersthat are installed on your computer. In the address bar, enter the IP address of the router - http://192.168.1.1.

The site will require authentication - login and password. If your provider does not set any specific data, then enter the standard ones - admin in the login and admin in the password. You can also find information on the login and password from the router control panel on the bottom of the router.

After all operations, we find ourselves to the router management page. First of all, indicate the protocol of your operator on the “WAN” tab in the “WAN connection type” line. If the address is provided automatically, we leave everything as is. If you need to register the IP address and DNS manually, then check the “No” box in “Obtain a WAN IP address automatically?” and enter the parameters below.

The main part setup is complete. Now - setting up WiFi. This is the "Wireless Network" - "General" tab.

• SSID - the name of your router;
  
• Hide SSID - whether you need to display the router name or not;
  
• Country code - select your country;
  
• Wireless network mode, Channel width - leave as is;
  
• Channel - it is advisable to set something other than automatic or the first - optimally 6 or 9. This setting will help you speed up your wireless Internet connection;
  
• Expanded channel - leave it as is;
  
• Authentication method is WEP, WPA or WPA2. The most modern is WPA2, so we install it. The rest of the settings are default.
  

You can also enter your own password in the WPA Pre-Shared Key field. That's all on this page - you can click "Apply".

Now go to “Administration”, where we click “Reboot” and “Exit”. The router will be completely ready for use after a reboot. This is all we wanted to tell you about setting up a router of this model. If you have any questions, ask them in the comments and we will definitely answer them. See you on the pages of our website!