Assemble HP Pavilion G6 with your own hands
Hello! One thing disassemble laptop, but it’s another thing entirely to assemble it. The second is sometimes more difficult than the first. But don't despair, you can easily assemble a laptop with the help of this guide with steady hands and a little luck. About everything - about everything, about 15 minutes. Let's begin. And we start with the instrument. If to disassemble the device you needed: a Phillips screwdriver, a pick, a cleaning cloth and thermal paste, then you can assemble it only with two hands and a screwdriver.
Obviously, the assembly process will be the reverse of the disassembly process. The last one we took out motherboard. This means that it will be first in the editing queue. Take the motherboard, turn it with the cooling system down and install it in the case. It is important to install the motherboard accurately, without distortions or backlashes. The motherboard should lie flat in its place.
After this, screw the motherboard to the case with a screw. It's in the lower left corner. Connect all wires and cables to the motherboard; without them, the device will not work.
Immediately behind the motherboard we insert an optical drive into the laptop case. Don't forget to connect it to your motherboard for it to work.
We're almost done with this part. Place the top panel and secure it with two bolts.
And now, carefully but quickly, he turns the laptop over. First of all, we fix the optical drive. Immediately after it, tighten 9 screws around the perimeter. The drive is tightened, the bottom is in place - wonderful!
Next we install the WI-FI module. We fix it with bolts and connect the antennas. When connecting antenna wires, it is important to remember which wire was connected to which connector and install them in the appropriate order.
Turns the laptop over again. Finally, we install the keyboard in its rightful place.
I hope you're not tired of turning it around yet? Turn the laptop over again with the bottom up and fix the keyboard. We install in parallel HDD and screw 3 bolts into the battery compartment.
With a victorious movement, we place the battery and slam the lid. Your mission has been completed, for which I congratulate you. Now try turning on the device - everything should be fine. Well, if not, check every single contact.
